AP® Physics 2: Algebra-Based Unit 14 flashcardsWaves, Sound, and Physical Optics
39 cards · about 10 minutes for the whole deck
Flashcard drill
Space flips the card, arrow keys move, and keys 1 to 4 rate how well you knew it.
- Position
- 1 / 39
- Due
- 39
- Mastered
- 0 / 39
This card: New
Flip the card before you rate it.
Wave pulse
A single disturbance that travels through a medium, like one flick sent down a rope. A wave is a repeating series of them.
Topic 14.1: Properties of Wave Pulses and Waves
Waves carry energy, not matter
A wave moves energy from place to place, but each bit of the medium just oscillates around its own spot. A floating cork bobs up and down as a wave passes.
Topic 14.1: Properties of Wave Pulses and Waves
Mechanical wave
A wave that needs a medium (a material) to travel through, like sound or a wave on a string. Sound can't cross a vacuum.
Topic 14.1: Properties of Wave Pulses and Waves
Transverse wave
A wave where the medium moves perpendicular to the direction the wave travels, like a wave on a string. Light is transverse too.
Topic 14.1: Properties of Wave Pulses and Waves
Longitudinal wave
A wave where the medium moves back and forth parallel to the direction the wave travels. Sound in air is longitudinal.
Topic 14.1: Properties of Wave Pulses and Waves
Compressions and rarefactions
The regions in a longitudinal wave where the medium is squeezed together (compressions) and spread apart (rarefactions).
Topic 14.1: Properties of Wave Pulses and Waves
Wave speed on a string
, where is the tension and μ is the mass per unit length. Tighter or lighter strings carry faster waves.
Topic 14.1: Properties of Wave Pulses and Waves
What sets wave speed
The medium sets the speed of a wave, not the amplitude or frequency. Shake a rope faster and you get a shorter wavelength at the same speed.
Topic 14.1: Properties of Wave Pulses and Waves
Wave period and frequency
The period T is the time for one full cycle; the frequency f is the number of cycles per second. , measured in hertz (Hz).
Topic 14.2: Periodic Waves
Wavelength
λ, the distance between two matching points next to each other on a wave, like crest to crest or compression to compression.
Topic 14.2: Periodic Waves
Wave equation
v = fλ for any periodic wave. In one medium, a higher frequency means a shorter wavelength, because the speed stays the same.
Topic 14.2: Periodic Waves
Snapshot vs. history graph
A displacement–position graph is a snapshot of the whole wave at one instant (shows λ). A displacement–time graph follows one point over time (shows T).
Topic 14.2: Periodic Waves
Pitch and loudness
Pitch is how high a sound seems and goes with its frequency. Loudness goes with its amplitude, which sets how much energy the sound carries.
Topic 14.2: Periodic Waves
Reflection at a boundary
When a pulse reaches a slower medium (or a fixed end), the reflected pulse is inverted. When it reaches a faster medium (or a free end), it reflects upright.
Topic 14.3: Boundary Behavior of Waves and Polarization
Transmitted wave
The part of a wave that crosses into the new medium. It stays upright and keeps the same frequency, but its speed and wavelength change.
Topic 14.3: Boundary Behavior of Waves and Polarization
Polarized light
Light whose electric field oscillates in only one plane. Only transverse waves can be polarized, which is evidence that light is transverse.
Topic 14.3: Boundary Behavior of Waves and Polarization
Wave intensity
Power per unit area, in W/m². A polarizing filter lowers the intensity of light passing through it, and two crossed filters can block it completely.
Topic 14.3: Boundary Behavior of Waves and Polarization
Electromagnetic wave
Oscillating electric and magnetic fields, perpendicular to each other and to the direction of travel. It needs no medium and travels at c in a vacuum.
Topic 14.4: Electromagnetic Waves
Speed of light
c = 3.00 × 10⁸ m/s in a vacuum, the same for every kind of electromagnetic wave, from radio waves to gamma rays.
Topic 14.4: Electromagnetic Waves
Electromagnetic spectrum
From longest to shortest wavelength: radio, microwave, infrared, visible, ultraviolet, X-rays, gamma rays. Shorter wavelength means higher frequency.
Topic 14.4: Electromagnetic Waves
Visible light colors
From longest to shortest wavelength: red, orange, yellow, green, blue, violet. Red has the lowest frequency, violet the highest.
Topic 14.4: Electromagnetic Waves
Doppler effect
A change in observed frequency when the source and observer move relative to each other: higher when they approach, lower when they separate.
Topic 14.5: The Doppler Effect
Size of a Doppler shift
The faster the source and observer move toward or away from each other, the bigger the shift. With no relative motion there's no shift.
Topic 14.5: The Doppler Effect
Superposition
When waves overlap, the total displacement at each point is the sum of the individual displacements. Afterward each wave carries on unchanged.
Topic 14.6: Wave Interference and Standing Waves
Constructive and destructive interference
Constructive: waves line up crest to crest and add to a bigger amplitude. Destructive: crest meets trough and they partly or fully cancel.
Topic 14.6: Wave Interference and Standing Waves
Beats
A slow rise and fall in loudness when two sounds of slightly different frequency play together. The beat frequency is .
Topic 14.6: Wave Interference and Standing Waves
Standing wave
A wave pattern that stays in place, made when waves reflect back and forth in a string or pipe and interfere. It has fixed nodes and antinodes.
Topic 14.6: Wave Interference and Standing Waves
Nodes and antinodes
Nodes are points of a standing wave that never move; antinodes swing the most. Neighboring nodes are half a wavelength apart.
Topic 14.6: Wave Interference and Standing Waves
Harmonics on a string or open pipe
With both ends fixed (or both open), and for n = 1, 2, 3, …. The fundamental (n = 1) has λ = 2L.
Topic 14.6: Wave Interference and Standing Waves
Pipe closed at one end
Closed end is a node, open end an antinode. Only odd harmonics fit: for n = 1, 3, 5, …, so the fundamental has λ = 4L.
Topic 14.6: Wave Interference and Standing Waves
Diffraction
The spreading of a wave as it passes an obstacle or goes through an opening. It's strongest when the opening is about as wide as the wavelength.
Topic 14.7: Diffraction
Single-slit dark bands
Dark bands appear where a sin θ = mλ (m = 1, 2, 3, …), where a is the slit width. A narrower slit or a longer wavelength spreads the pattern wider.
Topic 14.7: Diffraction
Central maximum
The wide, bright band in the middle of a single-slit pattern. It's twice as wide as the other bright bands.
Topic 14.7: Diffraction
Double-slit bright fringes
Bright where d sin θ = mλ, with d the slit spacing. For small angles the fringes are evenly spaced: on a screen a distance L away.
Topic 14.8: Double-Slit Interference and Diffraction Gratings
Young's double-slit experiment
Light through two narrow slits made a pattern of bright and dark fringes, which only waves can make. It was key early evidence that light is a wave.
Topic 14.8: Double-Slit Interference and Diffraction Gratings
Diffraction grating
Many evenly spaced slits. It obeys d sin θ = mλ like a double slit, but makes much sharper, brighter maxima, so it's used to measure wavelengths.
Topic 14.8: Double-Slit Interference and Diffraction Gratings
Thin-film interference
Light reflecting off the top and bottom of a thin film interferes. It makes the colors in soap bubbles and oil slicks.
Topic 14.9: Thin-Film Interference
Phase change on reflection
Light reflecting off a material with a higher index of refraction flips by half a wavelength (180°). Off a lower index, there's no flip.
Topic 14.9: Thin-Film Interference
Antireflection coating
A thin layer on a lens that cancels reflected light. With an index between air and glass, the simplest coating is thick, a quarter wavelength in the coating.
Topic 14.9: Thin-Film Interference