AP® Chemistry Unit 7 flashcardsEquilibrium
32 cards · about 8 minutes for the whole deck
Flashcard drill
Space flips the card, arrow keys move, and keys 1 to 4 rate how well you knew it.
- Position
- 1 / 32
- Due
- 32
- Mastered
- 0 / 32
This card: New
Flip the card before you rate it.
Reversible reaction
A reaction that can run both forward and backward, shown with ⇌. Products can turn back into reactants.
Topic 7.1: Introduction to Equilibrium
Dynamic equilibrium
The state where forward and reverse reactions run at the same rate, so concentrations stop changing even though particles keep reacting.
Topic 7.1: Introduction to Equilibrium
Equilibrium on a graph
On a concentration-versus-time graph, equilibrium starts where every line goes flat. The flat lines don't have to be at equal heights.
Topic 7.1: Introduction to Equilibrium
Forward and reverse rates
Starting with only reactants, the forward rate starts high and falls while the reverse rate starts at zero and rises, until the two are equal.
Topic 7.2: Direction of Reversible Reactions
Net direction of change
If the forward rate is bigger than the reverse rate, reactants are turning into products overall; if it's smaller, products are turning back into reactants.
Topic 7.2: Direction of Reversible Reactions
Reaction quotient (Q)
Products over reactants, each raised to its coefficient, using the concentrations or pressures right now, whether or not the system is at equilibrium.
Topic 7.3: Reaction Quotient and Equilibrium Constant
Equilibrium constant (K)
The value of Q once the system reaches equilibrium. It's constant at a given temperature, no matter what amounts you start with.
Topic 7.3: Reaction Quotient and Equilibrium Constant
Writing a K expression
For aA + bB ⇌ cC + dD, . Leave out pure solids and pure liquids.
Topic 7.3: Reaction Quotient and Equilibrium Constant
Kc and Kp
Kc uses molar concentrations; Kp uses partial pressures of gases. Both are written the same way from the balanced equation.
Topic 7.3: Reaction Quotient and Equilibrium Constant
ICE table
A grid of Initial, Change and Equilibrium amounts. The Change row follows the coefficients, so one known equilibrium value lets you fill in the rest.
Topic 7.4: Calculating the Equilibrium Constant
Calculating K
Plug equilibrium concentrations (or pressures) into the K expression. Make sure they're equilibrium values, not starting values.
Topic 7.4: Calculating the Equilibrium Constant
Large K
K much greater than 1: at equilibrium the mixture is mostly products, and the reaction essentially goes to completion.
Topic 7.5: Magnitude of the Equilibrium Constant
Small K
K much less than 1: at equilibrium the mixture is mostly reactants, and very little product forms.
Topic 7.5: Magnitude of the Equilibrium Constant
Reversing a reaction (K)
Writing the reaction backward gives a new constant of .
Topic 7.6: Properties of the Equilibrium Constant
Multiplying coefficients (K)
Multiplying every coefficient by n raises K to the nth power. Halving the equation gives K to the ½ power, the square root.
Topic 7.6: Properties of the Equilibrium Constant
Adding reactions (K)
When you add reactions together, multiply their K values to get the K of the overall reaction.
Topic 7.6: Properties of the Equilibrium Constant
Q < K
There's too little product compared with equilibrium, so the reaction runs forward, making more products, until Q = K.
Topic 7.7: Calculating Equilibrium Concentrations
Q > K
There's too much product compared with equilibrium, so the reaction runs in reverse, making more reactants, until Q = K.
Topic 7.7: Calculating Equilibrium Concentrations
Q = K
The system is already at equilibrium, so there's no net change.
Topic 7.7: Calculating Equilibrium Concentrations
Small-x approximation
When K is very small, x is tiny compared with the starting amount, so (0.10 − x) ≈ 0.10. Check afterward that x is under about 5% of the start.
Topic 7.7: Calculating Equilibrium Concentrations
Equilibrium particle diagram
Count the particles of each species in a box and use the counts like concentrations to estimate K, or compare Q with K to see which way the mixture will shift.
Topic 7.8: Representations of Equilibrium
Le Châtelier's principle
When a system at equilibrium is disturbed, it shifts in the direction that partly undoes the disturbance.
Topic 7.9: Introduction to Le Châtelier's Principle
Adding or removing a substance
Adding a reactant or removing a product shifts the equilibrium toward products; adding a product or removing a reactant shifts it toward reactants.
Topic 7.9: Introduction to Le Châtelier's Principle
Changing the volume of gases
Shrinking the volume (raising pressure) shifts the equilibrium toward the side with fewer moles of gas. Expanding it shifts toward more moles of gas.
Topic 7.9: Introduction to Le Châtelier's Principle
Changing temperature
Treat heat like a reactant in an endothermic reaction and like a product in an exothermic one. Heating shifts the reaction in the endothermic direction.
Topic 7.9: Introduction to Le Châtelier's Principle
What changes K
Only temperature changes K. Adding or removing substances or changing the volume changes Q, and the system shifts until Q equals the same K again.
Topic 7.10: Reaction Quotient and Le Châtelier's Principle
Temperature and K
For an exothermic reaction, raising the temperature makes K smaller. For an endothermic reaction, raising the temperature makes K larger.
Topic 7.10: Reaction Quotient and Le Châtelier's Principle
Solubility product (Ksp)
The equilibrium constant for a solid salt dissolving into its ions, like AgCl(s) ⇌ Ag⁺ + Cl⁻, with Ksp = [Ag⁺][Cl⁻]. The solid is left out.
Topic 7.11: Introduction to Solubility Equilibria
Molar solubility
The moles of a salt that dissolve per liter of a saturated solution. For AgCl, , so .
Topic 7.11: Introduction to Solubility Equilibria
Comparing solubility with Ksp
You can compare Ksp values directly only for salts that split into the same number of ions. Otherwise, calculate each molar solubility.
Topic 7.11: Introduction to Solubility Equilibria
Saturated solution
A solution holding as much dissolved solute as it can at that temperature, in equilibrium with undissolved solid. Then Q = Ksp.
Topic 7.11: Introduction to Solubility Equilibria
Common-ion effect
A salt is less soluble in a solution that already contains one of its ions. AgCl dissolves less in NaCl(aq) than in pure water.
Topic 7.12: Common-Ion Effect